| SPA-1X10GE-L-V2 Specifications |
| Product Compatibility | • Cisco Catalyst 6500 Series Switches |
| • Cisco 7600 Series Routers |
| • Cisco 12000 Series Routers |
| • Cisco XR 12000 Series Routers |
| • Cisco ASR 1000 Series Router |
| • Cisco CRS Carrier Routing System |
| • Cisco 10000 Series Router |
| Port Density per SPA | One 10 Gigabit Ethernet port |
| Physical Interface | 10-Gbps XFP optics |
| LED Indicators | SPA status-Bicolor green and amber LEDs encode the SPA status as follows: |
| • LED off-SPA is powered off |
| • LED amber-SPA is powered on and initializing |
| • LED green-SPA is powered on and operational |
| In addition to the status LED, the SPAs also have a bicolor LED dedicated to each port to indicate port status. The green and amber LEDs encode the port status as follows: |
| • LED off-Port is not activated by software |
| • LED amber-Port is activated by software, but there is a problem with the Ethernet link |
| • LED green-Port is activated by software, and there is a valid Ethernet link |
| Features and Functions | • Full-duplex operation |
| • 802.1Q VLAN termination |
| • 802.1ad QinQ termination (stacked VLAN processing) |
| • Jumbo frames support (9188 bytes) |
| • Support for command-line interface (CLI)-controlled online insertion and removal (OIR) |
| • 802.3x flow control |
| • Bridge protocol data unit (BPDU), Cisco Discovery Protocoland VLAN Trunking Protocol (VTP) filtering |
| • Layer 2 Protocol (BPDU, Cisco Discovery Protocol, and VTP) Tunneling |
| • Layer 2 access list (MAC address-based filtering) |
| • Up to 8000 VLANs per SPA and subject to a limit of 4000 VLANs per port for 802.1q |
| • Up to 5000 MAC accounting entries per SPA (source MAC accounting on the ingress, and destination MAC accounting on the egress) |
| • Up to 2000 MAC address entries for destination MAC address filtering per SPA, and up to 1000 MAC address filtering entries per port |
| • Per-port byte and packet counters for policy drops; oversubscription drops; cyclic-redundancy-check (CRC) error drops; packet sizes; and unicast, multicast, and broadcast packets |
| • Per-VLAN byte and packet counters for policy drops; oversubscription drops; and unicast, multicast, and broadcast packets |
| • Per-port byte counters for good bytes and dropped bytes |
| Other software features supported: |
| • Ethernet over Multiprotocol Label Switching (EoMPLS) |
| • QoS |
| • Hot Standby Router Protocol (HSRP) |
| • Virtual Router Redundancy Protocol (VRRP) |
| Reliability and Availability | OIR of the SPA within the SIP and the optics within the SPA |
| Network Management | Network management: |
| • Field-replaceable XFP modules |
| • Host-system CLI |
| • Simple Network Management Protocol (SNMP) |
| Inventory- and asset management-related MIBs: |
| • Entity-MIB (RFC 2737) |
| • Cisco-entity-asset-MIB |
| Fault management: |
| • Cisco-entity-field-replaceable unit (FRU)-control-MIB |
| • Cisco-entity-alarm-MIB |
| • Cisco-entity-sensor-MIB |
| Physical interface management: |
| • IF-MIB |
| • Etherlike-MIB (RFC 2665) |
| Other MIBs: |
| • Remote Monitoring (RMON)-MIB (RFC 1757) |
| • Cisco-class-based-QoS-MIB |
| • MPLS-related MIBs |
| • Ethernet MIB/RMON |
| Physical Specifications | • Weight: 0.75 lb (0.34 kg) |
| • Height: 0.8 in. (2.03 cm) (single height) |
| • Width: 6.75 in. (17.15 cm) |
| • Depth: 7.28 in. (18.49 cm) |
| Power | 19.9W |
| Environmental Specifications | • Storage temperature: -38 to 150°F (-40 to 70°C) |
| • Operating temperature, nominal: 32 to 104°F (0 to 40°C) |
| • Operating temperature, short term: 32 to 131°F (0 to 55°C) |
| • Storage relative humidity: 5 to 95% relative humidity |
| • Operating humidity, nominal: 5 to 85% relative humidity |
| • Operating humidity, short term: 5 to 90% relative humidity |
| • Operating altitude: -60 to 4000 meters |
| Compliance and Agency Approvals | Safety |
| • UL 60950-1 |
| • CSA C22 No. 60950-1 |
| • EN 60950-1 |
| • IEC 60950-1 |
| • AS/NZS 60950 |
| • EN 60825-1 |
| • EN 60825-2 |
| • 21 CRF 1040 |
| EMC |
| • CFR 47, FCC Part 15-Class A |
| • ICES 003-Class A |
| • CISPR 22 Class A |
| • EN 55022 Class A |
| • EN 300386 Class A |
| • AS/NZS Class A |
| • VCCI-Class B |
| • EN 50082-1 |
| • EN 55024 |
| • IEC/EN61000-4-2 Electrostatic Discharge Immunity (8-kV contact, 15-kV air) |
| • IEC/EN61000-4-3 Radiated Immunity (10 V/m) |
| • IEC/EN61000-4-4 Electrical Fast Transient Immunity (2-kV power, 1-kV signal) |
| • IEC/EN61000-4-5 Surge AC Port (4-kV CM, 2-kV DM) |
| • IEC/EN61000-4-5 Surge Signal Port (1-kV indoor, 2-kV outdoor) |
| • IEC/EN61000-4-5 Surge DC Port (1 kV) |
| • IEC/EN61000-4-6 Immunity to Conducted Disturbances (10 Vrms) |
| • IEC/EN61000-4-8 Power Frequency Magnetic Field Immunity (30 A/m) |
| • IEC/EN61000-4-11 Voltage Dips, Short Interruptions, and Voltage Variations |
| Telecom |
| • IEEE 802.3ae (10 Gigabit Ethernet interface SPA) |
| Industry Standards |
| The Cisco 1-Port 10-GE SPA is designed to meet the following requirements (some qualifications are currently in progress): |
| • SR-3580-Network Equipment Building Standards (NEBS): Criteria levels (Level 3 compliant) |
| • GR-63-CORE-NEBS: Physical protection |
| • GR-1089-CORE-NEBS EMC and safety |
